Numerical Investigation Of Turbulence Models for Separation Fluid Flow In an Annular Passage In Regenerative Pipe


Separation and reattachment of air flow through a sudden expansion in an annular passage with uniform heat after step are considered in this paper. The annular passage with step is applied in the design of many heat related applications where heat transfer is concerned. In this work, numerical simulation for many turbulence models is performed using computer fluid dynamics package (commercial software) to study the effect of step flow in an annular passage. The numerical results are compared with the preliminary experimental data. The annular passage, the flowing fluid was considered when heated uniformly from the beginning of the expansion. Constant heat flux approach was also considered for the heat transfer investigation. Annular pipe flow system having Reynolds number of 17,050 and uniform heat flux equal to 2098 W/m2 and a step ratio of D/d=1.8 was considered where d and D were representing the diameter of the pipe before and after expansion. Numerical simulation review shows that the reattachment point extends further with the increase of velocity for different occasions. Finally, experimental results for surface temperature (Ts) and local Heat transfer (h) are compared with CFD results after expansion for many turbulence models.

Keywords: reattachment, annular passage, recirculation, sudden expansion, Regenerative Pipe.

PDF Format of Article


  • W.T. Ashurst, F. Durst, C. Tropea, Two-dimensional separated flow: experiment and discrete vortex dynamics simulation, In: Symposium on Computation of Viscous–Inviscid Interactions. Colorado Springs, CO, USA, 1980.
  • P.K. Chang, Control of Flow Separation: Energy Conservation, Operational Efficiency and Safety, McGraw-Hill Book Co., New York, 1976.
  • P.D.L. Calzada, M. Valdes, M.A. Burgos, Heat transfer in separated flows on the pressure side of turbine blades, Numerical Heat Transfer Part A: Applications 60 (8) (2011) 666–684.
  • H.I. Abu-Mulaweh, A review of research on laminar mixed convection flow over backward- and forward-facing steps, International Journal of Thermal Sciences 42 (9) (2003) 897–909.
  • B. Wang, H.Q. Zhang, X.L. Wang, A time-series stochastic separated flow (TSSSF) model for turbulent two-phase flows, Numerical Heat Transfer Part B: Fundamentals 55 (1) (2009) 73–90.
  • Y. Zhang, L. Li, H.B. Ma, M. Yang, Effect of Brownian and thermophoretic diffusions of nanoparticles on nonequilibrium heat conduction in a nanofluid layer with periodic heat flux, Numerical Heat Transfer Part A: Applications 56 (4) (2009) 325–341.
  • E.G. Filetti, W.M. Kays, Heat transfer in separated, reattached, and redevelopment regions behind a double step at entrance to aflat duct, Journal of Heat Transfer 89 (2) (1967) 163–167.
  • C.S. Oon, Hussein Togun, Numerical simulation of heat transfer to separation airflow in an annular pipe, International Communications in Heat and Mass Transfer 39 (2012) 1176-1180.
  • Tlili, I., Timoumi, Y., & Nasrallah, S. B. (2008). Thermodynamic analysis of the Stirling heat engine with regenerative losses and internal irreversibilities. International Journal of Engine Research, 9(1), 45-56.
  • Hussein Togun, Tuqa Abdulrazzaq, S.N. Kazi, A. BadarudinA.A.H. KadhumE. Sadeghinezhad. Renewable and Sustainable Energy Reviews Volume 39, November 2014, Pages 835–856.
  • Francis QuailThomas ScanlonMatthew Stickland, (2011) “Design optimisation of a regenerative pump using numerical and experimental techniques”, International Journal of Numerical Methods for Heat & Fluid Flow, Vol. 21 Iss: 1, pp.95 – 111.